Lead diameters from 0.4 to 1.3 mm without tool changes

Belt spacing 5, 10 and 15 mm

Output adjustable up to max. 8,000 units/hour (depends on belt quality and lead diameter)

Components are always tension released during processing (4-5 kg elastic)

Safe and strain-free handling of the components by bending rolls with adjustable pressure

Crimping deepness continuously adjustable

Bending angle also adjustable

Pitch (2,5 - 60 mm) and pin length (3 - 30 mm) can be read and continuously adjusted over a digital display

Parameters and belt width are adjustable with turning knobs (located outside the machine)

Repetitive accuracy of parameters 0.05 mm

Machine is PLC-controlled (Siemens) and switches off automatically under the following conditions: nominal pieces reached, end of or failure in belt

Electronic counter

Tools are driven by cam discs

Electric drive with tooth belt (three-phase motor)

Machine is very low-maintenance, since linear guides are located at flexible components (feed unit, bending unit, tension release, belt feeding)

Belt feeding takes place at the front of the machine

End of belt slides out at the back side of the machine

Components dro into ESD-box below the machine

Operation voltage: 230V/50Hz (standard), other voltages are available on demand

Length x width x height (without accessories): 600 x 500 x 510 mm

Weight: approx. 53 kg (without accessories)

 

Easy changeable tools (2-3 min) facilitate the production of the below mentioned standard forms

Special shapes are also possible

Tools are made with carbide to guarantee high durability

Tools illustration:

Bending form 1:

Cutting and bending from 0.4 - 1.3 mm wire diameters

Body diameter: max. 35 mm

With a printed board thickness of 1.6 mm, the lead penetration depth is then 1.5 0.1 mm (standard).

Distance between body and bending radius depends on width of the used bending finger

Options: 1.0 1.2 1.5 mm (standard = 1.5 mm)

Bending form 2:

Snap-in cutting, bending and crimping

Wire diameters from 0.4 - 0.9 mm

Body diameter: max. 35 mm

With a printed board thickness of 1.6 mm, the lead penetration depth is then 1.5 0.1 mm (standard).

Bending form 3:

Standoff cutting, bending and crimping

Wire diameters from 0.4 - 1.3 mm

Body diameter: max. 35 mm

With a printed board thickness of 1.6 mm, the lead penetration depth is then 1.5 0.1 mm (standard).

Bending form 4:

Upright / Crimping shapes: snap-in, standoff and straight cutting

Wire diameters from 0.4 - 0.9 mm without tool change

Body diameter: max. 5 mm

With a printed board thickness of 1.6 mm, the lead penetration depth is then 1.5 0.1 mm (standard).